MaxStream XBee OEM RF Modules
All MaxStream Products on Sale and Limited Quantities Available!
While Supplies Last!
View the complete list of Maxstream Products Available On Sale
 The XBee OEM RF Modules are a ZigBee/IEEE
802.15.4 compliant solution for low-cost, low-power
wireless sensor networks. The modules are easy-to-use and provide
reliable delivery of critical data between devices. Its small
form factor saves valuable board space.
The XBee RF Modules operate within the ISM 2.4 GHz frequency band. The
modules are optimized for use in US, Canada, Australia, Israel and Europe.
No configuration is necessary for out-of-box RF communications. The modules
default configuration supports a wide range of data system applications.
Advanced configurations can be implemented using simple AT commands.
NOTE: Large Quantity Discounts Are Available!
Features Applications Specifications Development Kit
XBee OEM RF Module Features
- ISM 2.4 GHz operating frequency
- U.FL. RF Connector, Chip or Whip antenna options
- Industrial (-40 to 85° C) temperature rating
- Advanced networking & low-power modes supported
- Approved for use in the United States, Canada and Europe
- XBee Xtender RF Bridge Available to Build Longer Range Networks
- View the MaxStream Governmental Agency Approval List
XBee OEM RF Module Applications
- Security Systems and Lighting Controls
- Home Automation & Building Control
- Home Appliances, Fire Alarms & C02 Alarms
- Monitoring of remote systems
- Sensor Data Capture in Embedded Networks
XBee OEM RF Module Specifications
| Performance |
| Power Output |
XBee: 1mW (0 dBm)
XBee PRO: 60mW (18 dBm), 100 mW EIRP*
|
Indoor Urban Range
|
XBee: up to 100 ft. (30 meters)
XBee PRO: up to 300 ft. (100 meters)
|
Outdoor RF line-of-sight Range
|
XBee: up to 300 ft. (100 meters)
XBee PRO: up to 1 mile (1.6 km)
|
| RF Data Rate |
250 Kbps |
| Interface Data Rate |
up to 115.2 Kbps |
| Receiver Sensitivity |
XBee: -92 dBm
XBee-PRO: -100dBm
|
| |
| Networking |
| Spread Spectrum Type |
DSSS (Direct Sequence Spread Spectrum) |
| Networking Topology |
Peer-to-peer, Point-to-point,
Point-to-multipoint |
| Error Handling |
Retries & Acknowledgements |
| Filtration Options |
PAN ID, Channel & Addresses |
| Channel Capacity |
XBee: 16 Channels
XBee-PRO: 12 Channels |
| Addressing |
65,000 network addresses available for each channel |
| Encryption |
128-bit AES (Coming Soon!) |
| |
| Power |
| Supply Voltage |
2.8 - 3.4 Volts |
| Transmit Current |
XBee: 45 mA (@3.3 Volts)
XBee-PRO: 270 mA (@3.3 Volts)
|
| Receive Current |
XBee: 50 mA (@3.3 Volts)
XBee-PRO: 55 mA (@3.3 Volts)
|
| Power-down Sleep Current |
< 10 µA |
| |
| General |
| Frequency Band |
2.4000 - 2.4835 GHz |
| Serial Data Interface |
3 Volt CMOS UART - No Configuration required |
| |
| Physical Properties |
| Size |
XBee: 0.960" X1.087" (2.438 cm X 2.761 cm)
XBee-PRO: 0.960" X1.297" (2.438 cm X 3.294 cm)
|
| Weight |
XBee: 0.10 oz (3 grams) - with U.FL. Connector
XBee-PRO: 0.14 oz (4 grams) - with U.FL. Connector
|
| Antenna Options |
1. U. FL. RF Connector
2. Chip Antenna
3. Wire Antenna |
| Operating Temperature |
-40 to 85°C (Industrial) |
| |
| Certifications |
| United States (FCC) |
XBee: OUR-XBEE
XBee-PRO: OUR-XBEEPRO |
| Canada (IC) |
XBee: 4214AA-XBEE
XBee-PRO: 4214A-XBEEPRO
|
| Europe (CE) |
ESTI |
| Class 1 Division 2 |
Approved |
| * When operating in Europe: XBEE-PRO Modules must be configured
to operate at a maximum TX power output level of 10 dBm (power level
is set using AT commands). Additionally, European regulations stipulate
an EIRP power maximum of 12.86 dBm (19mW) |
Manuals
ZigBee/802.15.4 OEM RF Development Kit
The OEM RF Development Kit contains the following:
- XBee-PRO OEM RF Module w/ integrated wire antenna
- XBee-PRO OEM RF Module w/ U.FL RF connector (to RPSMA antenna)
- XBee Module with Chip Antenna
- XBee Module with Integrated Wire Antenna
- XBee Module with U.FL RF connector (to RPSMA antenna)
- Half-wave, 2.1 dBi, dipole antenna w/ RPSMA connector
- RS-232 Interface Board
- RS-232 Aable
- 9V 1A Power Adapter
- 9V Battery Clip
- Serial Loopback Adapter
- Null Modem Adapter (male-to-male)
- Null Modem Adapter (female-to-female)
- Quick Start Guide
- CD (Testing and configuration software, documentation and development
tools)
- RF Cable Assembly (adapter for connecting RPSMA antenna to U.FL connector)
- USB Interface Board
- USB Cable
MicroDAQ.com accepts
Visa, MasterCard and American Express
All prices are in U.S. Dollars.
No U.S. sales tax
|
