HOBO Temp & External Input Data Logger
The HOBO Temp/External is a 2-Channel Ambient Temperature and External
Input Data Logger. It will measure
and record up to 7,943 readings. It's reading rate is user
selectable with sampling intervals being 0.5 seconds to 9 hours,
recording times up to 1 year. Additional features include programmable
start time/date, nonvolatile EEPROM memory which retains data even if
battery fails and an extendable internal temperature sensor.
Features and Specifications
- Capacity: 7,943
measurements total
- User-selectable
sampling interval: 0.5 seconds to 9 hours, recording times up to 1
year
- Readout and
relaunch with optional HOBO Shuttle
- Internal
temperature sensor on 4" wire can extend from case
- Models with
external input accept external
sensors for temperature, AC current, 4-20 mA and 0-2.5 Volts DC
- Precision
components eliminate the need for user calibration
- Drop-proof to 5
feet
- Mounting kit
included (hook/loop, magnet, and tape)
- Programmable start
time/date
- Memory modes: stop
when full, wrap-around when full
- Nonvolatile EEPROM
memory retains data even if battery fails
- Blinking LED light
confirms operation
- User-replaceable
battery lasts 1 year
- Battery level
indication at launch
- Operating range:
-4°F to +158°F (-20°C to +70°C), 0 to 95% relative humidity,
non-condensing, non-fogging
- Time accuracy: ±1
minute per week at +68°F (+20°C)
- Size/Weight: 2.4 x 1.9 x 0.8" (68 x 48 x 19 mm)/approx. 1 oz.(29 gms)
- Compatible with Keyspan USB 4-Port Serial Adapter for USB Connectivity
Temperature (internal sensor)
- Range: -4°F to +158°F (-20°C to +70°C)
- Range for internal sensor when used outside of case:
-40°F to +248°F (-40°C to +120°C)
- Accuracy: ±1.27°F (±0.7°C) at +70°F, see plot to the right
- Resolution: 0.7°F (0.4°C) at +70°F
- Response time still in air: 15 min. typical with sensor inside
case; 1 min. typical with sensor outside case
|
 |
External input accepts the following sensors:
- Wide range of temperature sensors (TMCx-Hx series)
- Split-core CTs for AC current (5 Models)
- 4-20 mA input cable (CABLE-4-20mA)
- 0-2.5 V DC input cable (CABLE
-2.5-STEREO)
|
External 2.5 volt input specifications
- 2.5 mm jack: external input ground, input, switched 2.5 V output;
external input ground connection is not the same as PC interface
connection ground and should not be connected to any external ground
- Input range: 0 to +2.5 Volts DC
- Accuracy: ±10 mV ±1% of reading
- Resolution: 10 mV (8-bit)Out power: +2.5 Volts DC at 2 mA, active
only during measurements
|
Software and Accessories
NOTE: A BoxCar Pro or
BoxCar starter kit is required
to operate any of the H8 Family loggers. Each Box Car starter
kit includes software, PC interface cable and software manual.
Ordering Information
| Description |
Part Number |
Qty 1-9 |
Qty 10+ |
|
| HOBO Temp/External, 2 channels Data Logger |
H08-002-02
|
$85.00 |
$79.00 |
 |
| Software Starter Kits - One
Required |
| BoxCar Pro 4.3 Software and Serial Cable Kit |
BCP4.3-DL
|
$110.00 |
$103.00 |
|
| BoxCar 3.7 Software and Serial Cable Kit |
BC3.7
|
$39.00 |
$37.00 |
|
| Optional Accessories |
| Extra/Replacement Batteries (pack of 5) - CR2032 lithium batteries |
HRB-Temp-5
|
$8.00 |
$7.00 |
|
| Extra Serial Interface Cable |
Cable-PC-3.5
|
$9.00 |
$8.00 |
|
| Glacier Clear Xtreme Protective Case (3.93" x 2.4" x 0.94") |
T1000.1
|
$9.00 |
call |
|
| Blue Xtreme Protective Case (3.93" x 2.4" x 0.94") |
T1000.4
|
$9.00 |
call |
|
| USB 4-Port Serial Adapter |
USA-49WG
|
$149.00 |
call |
|
| Waterproof Temperature
Sensors |
| 1ft Air/Water/Soil temperature sensor |
TMC1-HD
|
$28.00 |
$26.00 |
|
| 6ft Air/Water/Soil Temperature Sensor |
TMC6-HD
|
$30.00 |
$28.00 |
|
| 20ft Air/Water/Soil temperature sensor |
TMC20-HD
|
$35.00 |
$33.00 |
|
| 50ft Air/Water/Soil temperature sensor |
TMC50-HD
|
$40.00 |
$38.00 |
|
| Stainless Steel Temperature
Probe |
| Stainless Steel Temperature Probe (4" Probe with 6' Cable) |
TMC6-HC
|
$75.00 |
$69.00 |
|
| Voltage |
| Voltage Input Cable |
Cable-2-5-Stereo
|
$8.00 |
$7.00 |
|
| Voltage Transmitters |
| conLab AC Voltage Transmitter - 150 VAC |
T-CON-ACT-150
|
$135.00 |
call |
|
| conLab AC Voltage Transmitter - 300 VAC |
T-CON-ACT-300
|
$135.00 |
call |
|
| 4-20mA |
| 4-20 mA Cable |
Cable-4-20ma
|
$22.00 |
$17.00 |
|
| Split Core AC Sensors |
| 0-20 Amp split-core AC Current Sensor |
CTV-A
|
$86.00 |
$80.00 |
|
| 0-50 Amp split-core AC current sensor |
CTV-B
|
$86.00 |
$80.00 |
|
| 0-100 Amp split-core AC current sensor |
CTV-C
|
$86.00 |
$80.00 |
|
| 0-200 Amp split-core AC Current Sensor |
CTV-D
|
$109.00 |
$101.00 |
|
| 0-600 Amp split-core AC Current Sensor |
CTV-E
|
$109.00 |
$101.00 |
|
| Carbon Dixoide |
| Telaire 7001 Carbon Dioxide (CO2) Monitor |
TELAIRE-7001
|
$449.00 |
$439.00 |
|
| Telaire CO2 Monitor to Data Logger Cable |
Cable-CO2
|
$25.00 |
$23.00 |
|
| Standard NIST Calibration Service |
- To order
external sensors and input cables for Temperature, AC Current,
4-20mA or 0-2.5 Volts DC click here.
- You may change quantities from within your cart.
- If you do not wish to order online call us toll free at 877-275-9606
between the hours of 9-5 Eastern Standard time.
`
MicroDAQ.com accepts
Visa, MasterCard and American Express
All prices are in U.S. Dollars.
No U.S. sales tax
|
