Web600 Remote Monitoring System

• Temperature Range of 10°F to 230°F
• Waterproof Sensor Measures Temperature of Fluids in a Pipe
• 304 Stainless Steel Probe and a Brass WEL-B Thermowell
• Includes 8ft Cable

• Weatherproof Temperature Sensor for Outdoor Use
• Sensitive Temperature element in a Stainless Steel Tube Sheathe
• Sensor is Mounted Inside a Ventilated, Treated Weather Resistant PVC Shield
• Mounted on a Weatherproof Outlet Box for Easy Outdoor Installation
• Includes 8 ft Cable

• Small Sealed General Purpose Temperature Probe for Indoor/Outdoor Use
• Suitable for Wet, Dry or Dirty Environments
• Compatible with Sensaphone Units
• Includes 12 ft Cable and Mounting Hardware

• Small Sealed General Purpose Temperature Probe for Indoor/Outdoor Use
• Temperature Range of -85°C to 140°C (-121°F to 176°F)
• Suitable for Wet, Dry or Dirty Environments
• Compatible with Sensaphone Units
• Includes 12 ft Cable and Mounting Hardware

• Small Sealed General Purpose Temperature Probe for Indoor/Outdoor Use
• Suitable for Wet, Dry or Dirty Environments
• Compatible with Sensaphone Units
• Includes 12 ft Cable and Mounting Hardware

• Attractive Wall-Mounted Enclosure
• Precision Room Temperature using Wall Mounted Housing
• Beige Plastic Enclosure with a Tan Metal Face Plate
• Includes Wall Mounted Housing
• Requires Cable (#FGD-0010)

• Buffers Momentary Temperature Fluctuations
• Prevent Alarm Dial Out for Defrost Cycles, Opening of Doors and Fans Circulating Air
• Ideal for Cold Storage Temperature Monitoring

• Monitors Air Temperatures from 6.7°C to 43°C (20°F to 110°F)
• Triggers Alarm when Temperature Reads out of Set Temperature Limits
• Multiple Sensors can be Wired in Parallel to a Single Input
• Can be Mounted to any Wall or Vertical Surface
• Requires no Power for Operation

• Temperature Range of -85°C to 140°C (-121°F to 176°F)
• Buffers Momentary Temperature Fluctuations
• Prevent Alarm Dial Out for Defrost Cycles, Opening of Doors and Fans Circulating Air
• Ideal for Cold Storage Temperature Monitoring

• Monitors and Measures Humidity from 0 to 95%
• Transmits Humidity Readings to a Sensaphone Monitor
• Programmable High and Low Alarms
• Can be Used with any Sensaphone Monitor that Allows 4-20mA Inputs
• Requires Power Supply FGD-0053 or FGD-0070

• Required For Any Sensor Needing a 24 Volt DC Power Supply
• 24 VDC

• Protection from High Voltage Surges Through AC Power and Telephone Lines
• (2) LEDs Confirm Suppressor "Protection Present" and "Grounded" Statuses
• Voltage Compatibility: 120 Volts AC
• Output Capacity: 15 Amps
• Dimensions: 3.5" x 2.5" 1.75"

• Power Outage Monitoring Device to Detect Power Failures
• Plugs into Any 110 Volt AC Outlet for Operation
• Includes 15ft Length Cable
• Works with all Sensaphone Units

• Requires Hard-Wired 120VAC 60Hz Power
• Two Sets of Dry Alarm Contacts: One Form-A SPST and One Form-C SPDT
• Tandem Interconnect Capability Allowing up to 6 Devices to be Connected Together
• Battery Backup
• 90dBA Audible Horn is Included
• Compatible with all Sensaphone Models

• Monitor Levels of Carbon Dioxide from 0 to 2000ppm
• Compatible with Any Sensaphone with 4-20mA Input Signal
• Requires 24 Volts DC Power Supply to Operate (#FGD-0053)

• Measure CO Levels from 0 to 300 ppm with a Sensaphone Monitor
• -20°C to 50°C Operating Range with ±5% ppm Accuracy
• Compatible with Any Sensaphone That Accepts a 4-20mA Input Signal
• Requires a 24 Volts DC Power Supply to Operate (#FGD-0053)

• Measure Air Temperature in Clean Indoor Environment
• Enables Temperature Monitoring at a Location Away from the Sensaphone Unit
• Programmable High/Low Alarms
• Recommended to be Located in Clean, Dry Environments
• Requires Cable (#FGD-0010)

• Detects Entry or Intrusion
• Use on Most Windows or Doors
• Requires Wire (#FGD-0010) to Connect to Web600 Input
• Wire Several Switches Together in a Series

• Extends Water Detection Rope by 10 feet
• Up to 10 Extensions Can be Connected
• Compatible with the Zone Water Detector Sensor (#FGD-0056)
• Compatible with the Wireless Zone Water Sensor (#FGD-WSG30-ZONE)

• Connects Sensors to External Inputs
• Shielded Wire
• 50 Foot Length

• Detects Movement within a Forty Foot Area
• Designed to Monitor Unauthorized Entry or Intrusion
• Requires Cable (#FGD-0010)
• Multiple Motion Sensors can be Wired Together in a Series
• Battery LIfe about 3 to 5 Years

• Provides Uninterrupted Backup Power when Main Power Fails
• Up to 2 Hours of Backup Power
• Battery is Monitored by Charge Control Circuitry to Keep it Fully Charged
• Compatible with the FDG-WEB600

• Detects Presence of Water on Floor or False Ceiling Using 10 ft WaterRope Cable
• Up to 3 WaterRope Cables Can be Attached Together
• Operates on 2 AA Batteries
• Black Plastic Housing
• Dimensions: 5.5" x 3.3" x1.4"

Includes 10 ft Water Rope, Batteries, Adhesive Clamps, Metal Tapping Screws, Drywall Anchors and Rubber Feet

• Allows you to Use J Type Thermocouple with a Sensaphone
• Converts J-Type Thermocouple to 4-20mA Input Signal
• Compatible with any Sensaphone with 4-40mA Inputs

• Detects the Presence of Water on a Horizontal Surface
• Can be used with all Sensaphone Models
• Multiple Sensors can be Wired in a Series
• Battery Life 3 to 5 Years
• Alarm will Trigger without Water Present when Battery is Low